Indicates amount of trim adjustment applied above or below the
reference volume setting of your PedWoofer. (page 14)
Selects the frequency to be adjusted by the parametric
Selects how wide a range of frequencies will be adjusted by the
parametric equalizer. (page 13)
Reduces the woofer’s output at those frequencies selected by the
parametric equalizer. (page 13)
Program Equalization indicators
Light indicates selected Reference or EQ program. (page 14)
Turns ampli er on or off. (page 12)
Lights when ampli er volume is muted. (page 7 and 18)
Lights green when the ampli er is operating and turns yellow
when the ampli er is in standby mode. Turns red to indicate that
ampli er has entered protection mode. (pages 7 and 12)
Sets correct PedWoofer phase (0°, 90°, 180°, or 270°) to best match
your satellite speakers and room. (pages 12 and 14)
Sets the low frequency crossover between the PedWoofers and your
satellite speakers. A detent is provided for the THX/EXT setting.
Sets the reference volume level of the connected PedWoofers.
A detent is provided for the THX/REF setting. (pages 13 and 14)
Ampli er Front Panel
Items in gray area are found on SA-8200 ampli er only
To Next Page
Loading...
