Atlantic DORIS - Installing the Device; Location of the Device

17
The dev ic e y ou have just purchased was submitt ed to many te sts and chec ks ensur ing it s quality.
We thank y ou for y our choic e and trust. We ho pe you will be fully satisfied .
A few recommendations:
Read the instructions before installing the device.
Power the device off before intervening on it, and check the power supply voltage.
Store the instructions, even after installing the device.
Characteristics of the device:( shown o n the machine’s infor mation label )
Cat C : Complies with EU standards for this category.
IP24 : Protected against water projections.
Classe II : Dual insulation.
INSTALLING THE DEVICE
1) Location of the device
- This device was designed to be installed in resi-
dential premises. In any other case, please call
your distributor.
- Installation must comply with the standards
currently enforced in the country of use.
- Locate the heater within minimum distances
from obstacles.
Do not install the device :
• In a draft likely to affect its control (under
centr al ised mechan ical ven tilati on, etc…).
• Under a fixed mains outlet.
• Inside zones 0 and 1 in bathrooms.
The device is to be installed so that switches and other
controls cannot be touched by a person in the bath or sho-
wer, except in the UK where IEE Regulations 701.512.2 and
701.512.3 apply. These allow the use of IP24 rated products
and their integral controls in Zone 2 and ouside zones.
Volume
3
Volume
2
60 cm
60 cm
60 c
m
3m
2,25 m
Volume
1
150 mm mini
200 mm mini
150 mm mini