25
OPERATING MODES
Several operating modes are available:
Comfort mode
You set your temperature when you are present. The appliance continuously
follows the set comfort temperature. This temperature is also that applied in
Programming mode for the Comfort phases.
Eco mode
This mode is used for short periods of absence (<48h). The Eco temperature is
always at least 2 °C below the Comfort temperature. This temperature is also
that applied in Programming mode for the Eco phases.
Programming mode
The appliance follows internal programs for each day of the week. These
programs define at what time of day the appliance must follow the Comfort
temperature (temperature set in Comfort mode) or the Eco temperature (Comfort temperature - 2
°C). Some programs are predefined. They can be personalised (see "Personalising a program").
To use the programming mode, you must first set the time and day in the Settings .
If the appliance receives commands via the pilot wire link:
- it follows the Off and Frost Protection priority commands.
- it follows the Comfort, Comf-1, Comf-2 and Eco commands only outside of Programming
mode.
Use
INITIAL SWITCH-ON
Press any button to activate the display.
When it is first powered on, Comfort mode is selected, and the temperature is set to 19 °C.
When the appliance is heated for the first time, a slight odour may be noted. This results from the
evacuation of any traces linked to the manufacture of the appliance. The first time your appliance
is started up, we recommend that you set it to heat to 28 °C for 1 hour.
COMFORT MODE
Selecting Comfort Mode
Setting the temperature
Use the buttons to set the temperature (desired temperature).
To Next Page
Loading...
