14
If the pilot wire is connected to a programming control unit, a timer or controller, programming of the heat
pump should not be done, or as appropriate, programming with the same temperature periods on both
systems.
Your unit is in Comfort mode:
Command on your
programming box
Lowering
COMFORT
Room temperature set in Comfort mode.
CONF is turned on.
COMFORT -1°C
CONF is turned on. The room temperature stabilizes at -1°C at Comfort
temperature.
COMFORT -2°C
CONF is turned on. The room temperature stabilizes at -2°C at Comfort
temperature.
ECO (
Comfort -3°C
)
CONF is turned on. and are alternatively displayed.
The Comfort temperature cannot be changed because the programming order is
Eco.
FROST PROTECTION
(
fixed setpoint + 7°C
)
CONF is turned on. and are alternatively displayed.
TURNED OFF
Heating or cooling immediate shutdown (
used for load shedding
).
is displayed when you press on a button and then turns off.
NB :
In the absence of pilot wire command, the device will operate at the temperature set with the buttons and
Turned Off and Frost Protection commands have priority over ECO and Comfort CONF modes.
This mode allows you to have the desired room temperature. The fan adjusts its speed to the needs.
If the screen is not illuminated, just press any key to turn it on.
To activate the Comfort mode, press
several times on until the selection
arrow is on COMFORT mode
The temperature set in Comfort mode will
be displayed.
The screen then goes to sleep.
During the cooling cycle, the recommended Comfort temperature is 26°C. It can vary between 17.5°C and
33°C.
To change the displayed
temperature, press on
or .
The selected temperature is displayed on the
screen. The fan is running.
COOLING YOUR ROOM:
COMFORT
MODE
HOW TO ACTIVATE THIS MODE?
HOW TO CHANGE THE DESIRED TEMPERATURE?
To Next Page
Loading...
