F 1.0 1
F_1.0_01_GB.fm 1-2
F 1.0 Maintenance
1 Notes regarding safety
f
Maintenance work: Maintenance work may only be carried out when the engine is
at a standstill.
Secure the paver finisher and the attachments against inadvertent starting before be-
ginning any maintenance work:
- Set the drive lever to the center position and the speed preselector to zero.
- Remove the traction drive fuse from the operating panel.
- Remove the ignition key and the battery main switch.
f
Lifting and jacking up: Secure lifted machine parts (e.g. screed or hopper) against
lowering by means of mechanical supports.
m
Spare parts: Use only approved parts and install them according to the specifica-
tions! If in doubt, contact the manufacturer!
f
Re-commissioning: Mount all protective devices before re-commissioning the paver
finisher.
f
Cleaning: Cleaning must not be carried out while the engine is running.
Do not use any inflammable substances (such as petrol).
Avoid directly cleaning electrical parts and insulation material with a steam jet; cover
them up beforehand.
f
Working in closed environments: Exhaust fumes must be led into the open. Pro-
pane gas bottles must not be stored in closed rooms.
m
In addition to these Maintenance Instructions, the Maintenance Instructions of the en-
gine manufacturer must always also be observed. All other maintenance work and in-
tervals noted in these instructions are also binding.
A
The instructions for the maintenance of the optional equipment are included in the
sub-chapters of this chapter.
To Next Page
Loading...