F 10.0 4
F_10.0_01_GB.fm. 4-6
4 Cleaning
- Clean all parts which come into contact with the material to be laid.
- Spray the polluted parts with the separating agent spray equipment (o).
m
Before cleaning with high pressure jet, lubricate all the bearings with grease as spec-
ified.
- Clean the machine with water after laying mineral mixes, lean concrete etc.
m
Do not spray water on the bearings,
electric or electronic parts.
- Remove the residue of the material
laid.
m
After cleaning with high pressure jet, lubricate all the bearings with grease as speci-
fied.
f
Risk of slipping! Take care of the clean-
liness of the walkways and steps, make
sure that they are free of grease and oil.
To Next Page
Loading...