Atlas Copco DYNAPAC Svedala Demag DF 115 C - Vibration Acting on the Entire Body; Vibrations Acting on Hands and Arms; Electromagnetic Compatibility (EMC)

B 23
B 635_DEM.D 23-24 01- 01.07.
7.7 Vibration acting on the entire body
When the machine is used properly, the weighted effective acceleration values at the
driver’s seat of a
w
= 0.5 m/s
2
according to prEN 1032-1995 draft are not exceeded.
7.8 Vibrations acting on hands and arms
When the machine is used properly, the weighted effective acceleration values at the
driver’s seat of a
hw
= 2.5 m/s
2
according to prEN 1033-1995 draft are not exceeded.
7.9 Electromagnetic compatibility (EMC)
The following limit values are observed according to the stipulations of the EMC di-
rective 89/336/EEC/08.95:
- Interference emission according to DIN EN 50081-1/03.93:
< 40 dB µV/m for frequencies of 30 MHz - 230 MHz measured at a distance of 3 m
< 47 db µV/m for frequencies of 20 MHz - 1 GHz measured at a distance of 3 m
- Interference immunity against electrostatic discharge according to DIN EN 61000-
4-2/03.96 (ESD):
The paver finisher did not show any discernible reactions to contact discharges of
± 4 KV and to air discharges of ± 8 KV.
The modifications according to test criterion „A“ are being met, i.e. the paver finish-
er continues to work without malfunction during the test.
A
Electrical or electronic components and their arrangement may only be modified after
written approval by the manufacturer has been obtained.