F 4.1 3
F_4.1_01_GB.fm 3-8
1.2 Points of maintenance
Auger - outer bearing (1)
The grease nipples are located on each
side on the top of outer bearing.
These are to be lubricated after work, to
expel the eventually penetrated bitumin
residue while hot and to keep the lubri-
cation of the bearing.
A
In case of auger extension, slightly un-
tighten the outer rings for the first lubri-
cation of the outer bearings, ensuring
better venting.
Following the lubrication the outer rings
shall be retightened properly.
A
Fill the new bearings using sixty strokes
of the grease gun.
Auger planetary gear (2)
-For checking the oil level unscrew
the inspection plug (A).
A
In case of proper oil level, the oil is at the
lower edge of the inspection port or a lit-
tle oil flows from the hole.
Schneckaula.Tif
6x
To Next Page
Loading...