F 4.1 7
F_4.1_01_GB.fm 7-8
For filling in the oil:
- Unscrew the bolts (B) at the upper
cover of the auger case.
- Remove lid (C).
- Fill in oil until the correct level is
achieved.
- Remount the lid.
- Check the oil level once again using
the dipstick.
Change the oil
A
Change the oil when the engine is at op-
erating temperature.
- Place a suitable dish under the auger
cases to catch the oil.
- Untighten bolts (D) on the perimeter of
the auger shaft flange.
A
The oil flows out between the flange and
the auger housing.
- Fully drain the oil
- Retighten the flange bolts (D) to cor-
rect tightness, diagonally.
- Fill in the specified oil through the
open upper cover (C) of the auger
housing, until the oil level comes to the
approprite height on dipstick (A).
- Refit the lid (C) and bolt (B) properly.
Augerdrive_dip_DEM.bmp/augerdrive_chain_DEM.bmp
A
B
C
D
To Next Page
Loading...