Atlas Copco LP 13-30 P User Manual

Transport
During transport make sure the power pack is
secured. Ensure that the power pack is upright
during transportation and lifted with approved lifting
equipment.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
►
Keep your hands away from the start and stop
device until you are ready to start the machine.
►
Learn how the machine is switched off in the
event of an emergency.
►
Stop the machine immediately in all cases of
power supply interruption.
Operating
Preparation before starting
The following checks must be made each time you
start to use the power pack. All these checks
concern the serviceability of the power pack. Some
concern your safety:
◆
Clean all safety labels. Replace any that are
missing or cannot be read.
◆
Inspect the power pack and hoses generally for
signs of damage.
◆
Ensure that the by-pass valve moves freely. For
maintenance see "Every day".
◆
Remove dirt and debris especially from the
linkages and hydraulic oil cooler.
◆
Check for oil and fuel leakages beneath the
power pack.
◆
Ensure that the hydraulic couplings are clean
and fully serviceable.
◆
Check all fastenings.
◆
Check the hydraulic oil level and add as
necessary.
◆
Check the engine oil level and add oil as
necessary.
◆
Make sure the fuel filler cap is tightly closed.
◆
Place the power pack in a safe position, to
prevent tilting during operation.
◆
Ensure that any machines you plan to use are
compatible with the power pack model used.
◆
Ensure that you have adequate fuel for the job.
Top up as necessary, taking care not to overfill.
◆
If the power pack has a recoil starter for starting
the engine, the cord must not be wound around
the operator's hand when starting the engine.
The first time the power pack is started with new
hoses, these will take approx 1.5 litres (0.4 US gal)
of oil to fill up. Add this amount of oil after the first
start-up.
Start and stop
Starting the engine
1. Turn the engine switch (A) to position ON.
OFFOFF
ONON
A
A
2. Turn on the fuel by setting the fuel control (B)
to the ON position.
3. Move the choke control (C) to the CLOSE
position. If the engine is warm, or the air
temperature is high, move the choke control to
the OPEN position.
Safety and operating instructions LP 13-30 P
14 © Construction Tools EOOD | 3392 5254 01 | 2017-04-13
Original instructions

Atlas Copco LP 13-30 P Specifications

General

Brand	Atlas Copco
Model	LP 13-30 P
Category	Power Pack
Language	English