5. Pull out the starter rope (D) until it resists.
Release the handle so the starter rope goes
back again, and then pull the starter rope until
the engine starts.
6. As the engine warms up, gradually move the
choke control (C) to the OPEN position.
Before usage, the power pack must be allowed to
warm up for several minutes to its working
temperature.
Stopping the engine
1. Turn the engine switch (E) to position OFF.
2. Turn off the fuel by setting the fuel control (B) to
the OFF position.
When taking a break
◆
During all breaks you must place the machine
in such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
◆
Switch off the power supply in the event of a
longer break or when leaving the workplace.
Maintenance
Regular maintenance is a basic requirement for
the continued safe and efficient use of the
machine. Follow the maintenance instructions
carefully.
◆
Before starting maintenance on the machine,
clean it in order to avoid exposure to hazardous
substances. See “Dust and fume hazard”.
◆
Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
◆
When cleaning mechanical parts with solvent,
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
◆
For major service of the machine, contact the
nearest authorised workshop.
◆
After each service, check that the machine's
vibration level is normal. If not, contact the
nearest authorised workshop.
Every day
Never perform maintenance when the power pack
is running.
◆
Clean and inspect the machine and its functions
each day before start working.
◆
Conduct a general inspection for leaks and
damage and wear.
◆
Disassemble the by-pass valve and clean it,
replace the o-ring if worn.
◆
Change damaged parts immediately.
◆
Replace worn components in good time.
◆
Never use the equipment if you suspect that it
is damaged.
◆
Never strike or abuse the equipment.
◆
Make sure that all the attached and related
equipment, such as hoses and POD (power on
demand) are in good condition.
◆
Check hydraulic oil level.
◆
Check hydraulic couplings.
◆
Check hydraulic filter.
◆
Check engine oil level.
◆
All fasteners and other threaded components to
be tightened to the specified torque only.
◆
Check tightness of nuts, bolts, screws and hose
fittings after the first days of operation and there
after in accordance with the maintenance
schedule.
LP 13-30 P Safety and operating instructions
© Construction Tools EOOD | 3392 5254 01 | 2017-04-13
Original instructions
15
To Next Page
Loading...