►
Always make sure that no hose or other object
is in your way or in any other person's way.
►
Always make sure you are in a stable position
with your feet as far apart as your shoulder
width and keeping a balanced body weight.
DANGER Electrical hazard
The machine is not electrically insulated. If the
machine comes into contact with electricity, serious
injuries or death may result.
►
Never operate the machine near any electric
wire or other source of electricity.
►
Make sure that there are no concealed wires or
other sources of electricity in the working area.
WARNING Involuntary start
Involuntary start of the machine may cause injury.
►
Keep your hands away from the start and stop
device until you are ready to start the machine.
►
Learn how the machine is switched off in the
event of an emergency.
►
Stop the machine immediately in all cases of
power supply interruption.
WARNING Noise hazard
High noise levels can cause permanent and
disabling hearing loss and other problems such as
tinnitus (ringing, buzzing, whistling, or humming in
the ears). To reduce risks and prevent an
unnecessary increase in noise levels:
►
Risk assessment of these hazards and
implementation of appropriate controls is
essential.
►
Operate and maintain the machine as
recommended in these instructions.
►
Select, maintain and replace the working tool as
recommended in these instructions.
►
If the machine has a silencer, check that it is in
place and in good working condition.
►
Always use hearing protection.
►
Use damping material to prevent work pieces
from 'ringing'.
WARNING Nominal pressure
If the maximum nominal pressure for the hydraulic
machine is exceeded, it can result in material
damage and personal injury.
►
Always run the hydraulic machine with a tool
that does not require a continuously higher
pressure than the stated nominal pressure. See
section "Technical data".
DANGER Fire hazard
If a fire starts in the machine, it can cause injury.
►
If possible use an AB(E)-class powder
extinguisher, otherwise use a B(E)-type carbon
dioxide fire extinguisher.
Maintenance, precautions
WARNING Machine modification
Any machine modification may result in bodily
injuries to yourself or others.
►
Never modify the machine. Modified machines
are not covered by warranty or product liability.
►
Always use approved original parts, tools, and
accessories.
►
Change damaged parts immediately.
►
Replace worn components in good time.
WARNING Hot components
Under normal working conditions the engine
components, particularly the exhaust system, will
get hot. The hydraulic oil, pump, valve, and tank
can also reach high temperatures that can cause
burns.
►
Never touch a hot exhaust system, hydraulic oil,
pump, valve or tank.
WARNING Accessory hazards
Accidental engagement of accessories during
maintenance or installation can cause serious
injuries, when the power source is connected.
►
Never inspect, clean, install, or remove
accessories while the power source is
connected.
Storage, precautions
◆
Keep the machine and tools in a safe place, out
of the reach of children and locked up.
Safety and operating instructions LP 13-30 P
8 © Construction Tools EOOD | 3392 5254 01 | 2017-04-13
Original instructions
To Next Page
Loading...
Need help?
General