Service EN MT Focus 400
18
© Atlas Copco Industrial Technique AB - 9836 6294 01
Service
Preventing ESD problems
The components inside the tool and controller are sensitive to electrostatic discharge. To avoid future mal-
function, make sure that service and maintenance is carried out in an ESD approved work environment.
The figure below shows an example of an appropriate service work station.
Maintenance Instructions
Service recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guidelines:
■
Replace any defective or worn parts
Maintenance
There are certain general maintenance procedures you should perform to keep your MicroTorque system
clean and operating at its efficiency.
The system is a sophisticated instrument with many sensitive components.
A built-in service reminder can be configured in Tools Talk MT. When it is time to perform service on the
tool, a reminder is shown on the controller display.
Preventive Maintenance:
■
The system should never be exposed to harsh environment with rapid temperature changes or ex-
cessive dust.
■
Never expose the system to excessive vibration or high humidity.
■
Prevent overheating by use only in the permitted temperature range. Do not cover tool or controller or
power supply.
■
Cleaning of the tool and controller should be done regularly, but not with aggressive cleanser.
■
Check wear of the bit regularly.
■
Replace worn cables immediately.
Tools which have been opened by anyone else than Atlas Copco Industrial Technique AB, will not be ser-
viced.
Calibration and preventive maintenance is recommended at regular intervals once per year or after maxi-
mum 1.000.000 tightenings depending on which occurs sooner.
More frequent overhaul may be needed if the machine is used in heavy-duty operations.
If the machine is not working properly, it should immediately be taken away for inspection.
To Next Page
Loading...