Atlas Copco MT Focus 400 - Mechanical Installation; Wall Bracket Attachment; Rear Screw Attachment

Installation EN MT Focus 400
12
© Atlas Copco Industrial Technique AB - 9836 6294 01
I/O Description
EXT-IN-COM0 Connect to INT +24V
or external +24 V
(not at the same time)
DGND 0 V output
Mechanical installation of controller
The controller can be used in three ways:
■
Standing on a work bench.
■
Attached to a vertical surface using the wall bracket.
■
Attached to a vertical surface using screws from the rear side.
Wall bracket attachment
1. Attach the bracket to the surface using four 5 mm screws.
2. Pull out the plunger of the underside of the bracket and slide the controller into the bracket.
3. The controller is held in placed by the plunger when released.
Rear screw attachment
1. Remove the two crews holding the controller foot.
2. Drill two 5 mm holes in the surface, corresponding to the holes in the controller rear side. Leave
space over the holes for the connectors and the sound opening.
3. Attach the controller to the surface, preferrably with the removed screws.
NOTICE
■
The screws must not protrude into the controller more than 10 mm.