Atlas Copco MT Focus 400 - Controller Servicing; Opening the Cover; Changing the Front Panel

MT Focus 400 EN Service
© Atlas Copco Industrial Technique AB - 9836 6294 01
19
Controller
Required tools:
■
Screwdriver T8
■
Small flat-bladed screwdriver
Opening the cover
1. Remove the four screws indicated by circles.
Do not open the unit when faced down.
2. With the unit in upright position, open the housing carefully to the left.
Do not strain the flat cable from the front.
Do not loose the USB isolator.
Changing the front panel
1. Open the connector using a small screwdriver and carefully pull out the flat cable.
2. Unscrew the tool holder.
3.
■
Peel off the front panel. You can press from the inside on the display window.
■
Clean the inside surface of the cover with spirit.
Do not loose the light pipe.
4. Peel off the protection covers from the self-adhesive panel.
■
One cover protecting the self-adhesive sections.
■
One cover protecting the inside of the transparent window.
■
One cover protecting the outside of the transparent window.
5. Route the flat cable from the new front panel through the hole in the housing, attach the new front
panel to the housing.
Make sure the light pipe is correctly positioned.
6. Mount the tool holder.
7. Insert the flat cable into the connector, and close the connector by pressing in the movable part using
a small screwdriver.