Atlas Copco PHE 26 Series - Assembling Handle; Handle Assembly Steps; Assembling Back Gear Shaft; Back Gear Shaft Assembly Steps

PAGE
9
Repair Instruction No. 169.2/94
PHE 24/26/30-Range
1 Insert the AVS-rubber (1).
2 Fasten the handle cover (2) with screws.
3 Fasten the mains cable (4).
4 Fasten the strain relief (5).
5 Fasten the service cover (6) with screws.
F
After the high-voltage check, fit the
Softgrips (3).
Assembling the
handle
Assembling the
back gear shaft
0,05 mm
1
2
3
45 6
4
5
2
Illustration A
3 4 5 6 72 1 8
1
8
1 Push the following parts onto the back
gear shaft (3) in this order:
- washer (4)
- spring (5)
- coupling box (6)
- washer (7)
- tumble drive (2)
2 Press on the gear wheel (1) with a
distance of 0.05 mm to the tumble drive
(2) (illustration A). The smooth surface
must face the tumble drive (2).
3 Insert the locking ring (8).