Atlas Copco Power Focus 6000 LV - Page 12

Installation EN Power Focus 6000 LV
12
© Atlas Copco Industrial Technique AB - 9839 1081 01
EM Stop IO-cable connector: Molex Micro-Fit, 5-pin
Use the following pin configuration:
Pin Use
1 Do not use
2 Do not use
3 Attach an emergency button be-
tween pin 3 and pin 4
4 See pin 3
5 Attach an emergency button be-
tween pin 5 and pin 6
6 See pin 5
7 Connect a jumper between pin 7
and pin 8
8 See pin 7
9 Do not use
10 Do not use
Controllers between first and last
EM Stop IO-cable connector: Molex Micro-Fit, 5-pin
Remove plug or use the following pin configuration:
Pin Use
1 Do not use
2 Do not use
3 Do not use
4 Do not use
5 Do not use
6 Do not use
7 Do not use
8 Do not use
9 Do not use
10 Do not use
Last controller
EM Stop IO-cable connector: Molex Micro-Fit, 5-pin
Use the following pin configuration: