Control panel
Control panel of Elektronikon controller
General
Normally, the compressor runs in automatic operation, i.e. the electronic regulator loads, unloads, stops and
restarts the compressor automatically. LED (8) is then alight.
If required, the compressor can be unloaded manually. In this case, the compressor is switched out of
automatic operation, i.e. the compressor remains running unloaded unless it is loaded again manually.
Manual unloading
Press the key “Unload” (5). LED (8) fades. The message “Manually Unloaded” appears on the display.
Manual loading
Press the key “Load” (5). LED (8) lights up. The “Load” command does not force the compressor in loaded
condition, but it will switch the compressor to automatic operation again, i.e. the compressor will be loaded
if the air net pressure drops below the programmed level.
If the “Load” or “Unload” function is not indicated on the bottom line of display (2), press
“Menu” (5) until “Main Screen” appears above key (F1), then press “Main Screen”.
Instruction book
2920 1815 04 275
To Next Page
Loading...
Need help?
General
