• Avoid SMARTBOX operation close to inadequately protected personal medical devices such as
hearing aids and pacemakers. Consult the manufacturers of the medical device to determine if it is
adequately protected.
• Avoid SMARTBOX operation close to other electronic equipment which may also cause interference
if the equipment is inadequately protected. Observe any warning signs and manufacturer
recommendations.
• Respect a distance from the human body of at least 20 cm (8 inch) during SMARTBOX operation.
• Do not operate the SMARTBOX in areas where cellular modems are not advised without proper
device certifications. These areas include environments where cellular radio can interfere, such as
explosive atmospheres, medical equipment, or any other equipment which may be susceptible to any
form of radio interference. The modem can transmit signals that could interfere with this equipment.
SMARTLINK
The machine is SMARTLINK-ready.
SMARTLINK is Atlas Copco’s web-based platform to monitor compressed air installations. It is available
in 3 product levels:
•
SMARTLINK Service
SMARTLINK Service rules out all uncertainties. Scheduling maintenance visits becomes as simple
and easy as it should be; the service log book is always just one click away and the online link with
Atlas Copco allows to request and quickly receive quotes for spare parts or additional services.
This product level is free of charge and available for 3 years following the machine purchase.
• SMARTLINK Uptime
SMARTLINK Uptime keeps your compressors up and running. By e-mail and/or text, you receive all
relevant machine indications (warnings and shutdowns) in advance. Based on this information, you
can then take all necessary actions and measures to avoid the risk of a breakdown.
This product level is available as a free of charge 3-month trial.
•
SMARTLINK Energy
SMARTLINK Energy safeguards the performance of your equipment. It enables you to continuously
monitor and analyze the energy efficiency of the compressor room. You decide which performance
indicators, benchmarks and reports are created. You can make accurate and immediate improvements
when needed. The results can be used for energy monitoring according to ISO50001.
This product level is available as a free of charge 3-month trial.
Once a SMARTLINK level is chosen, gaining access is the next step. To gain access at least one machine
SMARTLINK-ready component (compressor, dryer, ...) is required. Follow the next steps:
• Gather the information about the SMARTLINK-ready machine(s) (e.g. picture of the data plate;
invoice,…)
• Go to the SMARTLINK web site http://www.atlascopco.com/smartlink
• Click on the left button in the screen below.
Instruction book
42 2920 1815 04
To Next Page
Loading...
Need help?
General
