PROCEDURE FOR BLEEDING THE CYLINDERS
OF ALL CHAIN-OVER-ROLLER STYLE LIFTS
(Removing air from the hydraulic system)
Current Atlas model chain-over-roller cylinder lifts include:
BP8000, 9KBP, BP9000, BP10000, BP12000, 9KOH, 9OHSC
PERFORM THIS PROCEDURE IMMEDIATELY AFTER INSTALLATION
and BEFORE YOU PUT A VEHICLE ON THE LIFT
1. Press the UP Button to raise
the Carriages (part to which
the arms attach inside both
Columns) about 18” o the
oor. DO NOT RAISE THE
CARRIAGES TO MAXIMUM
HEIGHT, JUST ENOUGH TO
REMOVE ANY SLACK FROM
THE CHAIN.
2. Disengage the Safety Locks on both Columns using
the Single Point Release Handle near the power unit
or by pulling the two Manual Release Cables located
on each carriage (depending on model of 2 Post Lift
you have). Depress the Lowering Valve handle and lower the arms completely to
the oor. Once the lift arms are resting on the ground maintain pressure on the
lowering valve handle for several seconds more.
Single Point Release Handle Manual Release Cable Lowering Valve
To Next Page
Need help?
General
