Atmel AVR ATtiny10 Series - Page 52

ATtiny10/11/12
52
Notes: 1. “Max” means the highest value where the pin is guaranteed to be read as low.
2. “Min” means the lowest value where the pin is guaranteed to be read as high.
3. Although each I/O port can sink more than the test conditions (20 mA at V
CC
= 5V, 10 mA at V
CC
= 3V) under steady state
conditions (non-transient), the following must be observed:
1] The sum of all I
OL
, for all ports, should not exceed 100 mA.
If I
OL
exceeds the test condition, V
OL
may exceed the related specification.
Pins are not guaranteed to sink current greater than the listed test conditions.
4. Although each I/O port can source more than the test conditions (3 mA at V
CC
= 5V, 1.5 mA at V
CC
= 3V) under steady state
conditions (non-transient), the following must be observed:
1] The sum of all I
OH
, for all ports, should not exceed 100 mA.
If I
OH
exceeds the test condition, V
OH
may exceed the related specification. Pins are not guaranteed to source current
greater than the listed test condition.
5. Minimum V
CC
for Power-down is 1.5V. (On ATtiny12: only with BOD disabled)
V
ACIO
Analog Comparator
Input Offset Voltage
V
CC
= 5V
V
IN
= V
CC
/2
40 mV
I
ACLK
Analog Comparator
Input Leakage Current
V
CC
= 5V
V
IN
= V
CC
/2
-50 50 nA
T
ACPD
Analog Comparator
Propagation Delay
V
CC
= 2.7V
V
CC
= 4.0V
750
500
ns
DC Characteristics – Preliminary Data (Continued)
T
A
= -40°C to 85°C, V
CC
= 2.7V to 5.5V for ATtiny10/11, V
CC
= 1.8V to 5.5V for ATtiny12 (Unless otherwise noted)
Symbol Parameter Condition Min Typ Max Units