Extraction ventilator schematics
CAUTION – The exhaust ventilator (S) is provided disassembled. Place it on the smoke
duct, fasten properly and test its smooth operation
1 - Motor
2 - Plate
3 - Rotating wheel (stainless steel)
4 - Nut with left-handed thread and washer
5 - Wing nut
6 - Screw
7 - Large gasket (2 pcs)
8 - Small gasket
4. Type and seating of shaped pieces into combustion area
1. For type
DC15E
DC18S
DC22S
DC25S
DC30SX
DC32S
DC50S
DC40SE
DC40SX
DC50SE
Roof of the lower combustion area must always be fully pressed against the boiler rear wall.
2. For type
DC75SE
Roof for this boiler type consist of two pieces – see figure (DC75SE – 2 x 500mm)
27. Heatproof shaped piece –
roof is for:
- for boiler (
DC15E,
DC18S) lenght
320 mm
- for boilers (DC22S, DC25S,
DC30SX, DC32S, DC40SE,
DC40SX) length 500 mm;
- for boilers (DC50S, DC50SE)
length 700 mm.
16
2
4
3
7 8
5
To Next Page
Loading...
