14- Generator indicator light and start up (Option):
Tilt the lever to the right (ON) to start up the generator.
The indicator lights up when the generator is running.
Tilt the lever to the left (OFF) to switch off the generator.
Refer to Section 4.6 – Generator.
15- Overload Indicator:
This light flashes when the work platform's capacity is exceeded.
Refer to Section 6.2 – Load control.
16- Tilt indicator:
This light comes on when the machine has reached the maximum
authorised tilt.
Refer to Section 6.1 – Tilt detection.
17- System fault / Maintenance indicator:
This light flashes slowly when a service / pre-scheduled maintenance
operation is required.
This light is on steady (and an alarm sounds) if there is a control system
fault. Refer to Section 6.3 – System fault.
18- Validation indicator light:
This light is on when the enable pedal is activated and a movement may
be controlled.
19- Preheat indicator:
This light comes on during the preheating phase and goes off once the
engine starts.
Refer to Section 4.2 – Combustion engine operation.
20- Engine fault indicator:
This light comes on ignition and must go out when the engine starts.
Once the engine is running, this indicator light comes on steady:
• When the alternator is faulty: the alternator no longer charges the battery
correctly.
• When the diesel engine oil pressure is abnormally low or when the
cooling fluid temperature is abnormally high: CUT the diesel engine as
quickly as possible.
To Next Page
Loading...
Need help?
General
