ATOMSTACK A 5 Pro - Step 4: Install laser and laser protective cover

S t e p 4
Installation Manual:
1. Fix the laser head on the slider board
with M5*8 countersunk head screws. The
screws must be tightened.
2. Insert the green protective covers on the
left and right sides.
3. Insert the front green protective cover.
4. Fix the front protective cover with M5*14
flat round head screws.
2
3
4
1
1
2
3
4
Y
X
Front protective
cover *1
Protective covers on both sides
*2
Laser head *1
M5*14 Flat round head
screw*1
M5*8 Countersunk screw
*2
Step4 Required components: