Name: ATOMSTACK A10 Pro
Brand: ATOMSTACK
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Equipment installation and use

1. Tear off the adhesive protect

paper from the silicone pad, align

the positioning posts on the

silicone pad with the mounting

holes on the pump, and paste the

silicone pad to pump body.

2. Insert the air tube into the

air pump port

3. The tube on the machine needs

be fixed with the connecting line by

the nylon tie. Be careful not to fix it

too tight to block the tube.

DC power

interface

Speed-

adjusting(switch)

knob

Other manuals for ATOMSTACK A10 Pro

Questions and Answers:

Need help?

Do you have a question about the ATOMSTACK A10 Pro and is the answer not in the manual?

General

Laser Power	10W
Laser Wavelength	455nm
Connectivity	USB
Engraving Accuracy	0.01mm
Output Voltage	12V
Engraving Area	410mm x 400mm
Material Compatibility	Wood, Plastic, Leather
Control Software	LaserGRBL
Laser Protective Cover	Yes
Input Format	BMP, JPG, PNG, DXF
Power Supply	AC 100-240V, 50/60Hz
Focusing Method	Fixed focus laser, no need to adjust focus before engraving