Need help?Do you have a question about the ATOMSTACK A24 PRO and is the answer not in the manual?
General| Frame Material | Aluminum Alloy |
|---|---|
| Weight | 10kg |
| Engraving Accuracy | 0.01mm |
| Output Voltage | 24V |
| Connectivity | USB |
| Software Compatibility | LaserGRBL, LightBurn |
| Laser Output Power | 24W |
| Laser Protective Cover | Yes |
| Supported File Formats | BMP, JPG, PNG, DXF |
| Data Transmission Method | USB |
| Power Supply | AC 100-240V, 50/60Hz |
| Supported Materials | Wood, Bamboo, Plastic, Leather |
| Power Supply Voltage | AC 100-240V, 50/60Hz |
| Dimensions | 150mm |
| Laser Type | Quad-Core Diode Laser |
Describes the steps for performing automatic focus using the device's display screen.
Explains how to configure automatic focus using custom buttons in LaserGRBL.
Explains manual Z-axis movement and handling of range exceeded prompts.
Guides on configuring automatic focus within the Lightburn software.
Instructions on initiating autofocus from both software platforms.
Lists important considerations before and during the use of power-off resume engraving.
Details the steps to enable and use the resume engraving feature on the device's screen.
To Next Page
