ATOMSTACK M100 - Part 7-1: Power Adapter Connection (Models Requiring Board); Adapter Board Connection Overview; Laser Module Power Connection

The voltage of the M100 module is DC24V, the following models need to add a
power adapter board to use. A5 10W; A5 20W; A5 30W; A5 PRO; A5 PRO+ ;A5
M30; A5 M40
P a r t 7 - 1 ： How to connect the power adapter
user's original
engraving machine
adapter
Adapter
for M100
module
The user's original adapter is connected to the one-to-two transfer cable, and one end of the one-to-two transfer cable is connected to the
air pump; the other end is connected to the control box. The 24V adapter in the M100 module is connected to the "POWER" position on
the adapter board. The 3PIN cable of the engraving machine originally connected to the laser is now connected to the adapter board
"Input c". Find the laser adapter cable from the accessories, connect one end of the 3PIN to the adapter board "Output", and connect the
4PIN end of the laser adapter cable to the M100 module
DC
24V
DC
12V