ATOMSTACK X7 Pro Series

Part 7：Web-side instructions
Select the WIFI you
want to connect to in
the WIFI interface in
the display settings
Connect the
same WIFI as
the display on
the PC
Click Go to
ESP3D Interface
to enter the
control page
The control page can
control the movement
of the laser, return to
zero, set the starting
point, and control the
laser switch
Enter the SD card page,
select the file to be
engraved or import the
file in the computer,
and move the laser to
the position to be
engraved
Click the button
to start carving
Open the browser
and enter the IP
address shown on
the display
Enter the page
and import the
index.html file
Laser fixed focus
method: use a
fixed focus lens
below the laser to
determine the focal
length
Click the contour
scan button to
confirm the
engraving range
Finish carving