1. Downloading LaerGRBL software
LaserGRBL is one of the most popular DIY laser engraving software in the world, LaserGRBL download website:
http://lasergrbl.com/download/
2. installing LaerGRBL
Double-click the software installation package to start
the software installation, and keep clicking Next until the
installation is complete.(Picture1)
Picture1: LaserGRBL
software installation
3. Adding custom buttons：
1.The software supports users to add custom buttons, you can add custom
buttons in the software according to your usage. We recommend the official
Custom Buttons from LaserGRBL. Custom button download address:
http://lasergrbl.com/usage/custom-buttons/，The downloaded custom
button is displayed as shown in the figure:(Picture2)
Picture 2:custom button
package
2.Next, we will load the custom buttons into the LaserGRBL software.
In the LaserGRBL software, right-click on the blank space next to the
bottom button (as shown in Picture 3) -> Import custom button, then
select the custom button zip file downloaded ATOMSTACK to import,
keep pressing Yes (Y) until no window pops up.(Picture 4、Picture 5）
Picture 3: adding custom button
To Next Page
Loading...
