SPECIFICATIONS
AUDIO SYSTEM
Gain Balanced output: 0 dB, unbalanced output: -6 dB
Frequency response 20 Hz to 20 kHz, ±0.2 dB
THD + Noise <0.01%, 20 Hz to 20 kHz, at maximum level
S/N
Analog In to Analog Out >109 dB, 20 Hz to 20 kHz, at maximum balanced
output (unweighted)
Analog In to Digital Out 110 dB, 20 Hz to 20 kHz, at full-scale output
(unweighted)
Digital In to Analog Out 115 dB, 20 Hz to 20 kHz, at maximum balanced
output (unweighted)
Crosstalk <-90 dB @ 20 Hz to 20 kHz, fully loaded
AUDIO INPUT
Number/signal type 6 mono (or 3 stereo), mic/line, balanced/
unbalanced, 6 with phantom power
Connectors (3) 3.5 mm captive screw, 6 pole, mono, balanced/
unbalanced
Impedance >10k ohms balanced/unbalanced
Nominal level -60 dBV,+4 dBu, -10 dBVadjustablevia input gain
Maximum level +21 dBuat rated THD+N whenmic gain is set to
0 dB
CMRR >60 dB typical
DC phantom power +48 VDC, ±10%(inputs 1-6) can be switched on or
off per input
AUDIO OUTPUT
Number/signal type 4 mono (or 2 stereo), line, balanced/unbalanced
Connectors (2) 3.5 mm captive screw, 6 pole, mono, balanced/
unbalanced
Impedance 100 ohms balanced, 50 ohms unbalanced
Gain error ±0.1 dB channel to channel
Maximum level (Hi-Z) >+21 dBu balanced, >+15 dBu unbalanced
AUDIO PROCESSING
A/D, D/A conversion 24-bit,48 kHz
AEC tail length >200 msec
AEC convergence Up to 60 dB/sec
Noise cancellation Up to 20 dB, software selectable
EXP PORT
Transmission type Proprietary
Connector 1 RJ-45
Inputs 16 channels Rx
Outputs 16 channels Tx
Audio format Uncompressed, 24-bit, 48 kHz
EXP cable Shielded CAT6 up to 10 meters
(1 foot cable included)
USB AUDIO PORT
Connector 1 rear panel USB mini-B
USB standards USB 2.0, high speed
AT PORTS (DMP 64 PLUS AT MODELS ONLY) — AUDIO TRANSPORT
Transmission Dante/AES-67, software selectable
Connectors 2 RJ-45, 2-port 1 Gbps switch to Dante interface
Inputs 32 channels Rx
Outputs 16 channels Tx
Audio format Uncompressed, 24-bit, 48 kHz
Latency Deterministic, based on user selections: 0.25 ms,
0.5 ms, 1.0 ms (default), 2.0 ms, 5.0 ms
VOIP PORT (DMP 64 PLUS V MODELS ONLY)
Connector 1 RJ-45
Data rate 10/100/1000 Base-T
Signaling protocol Session Initiation Protocol (SIP), RFC 3261 and
related RFCs
Discovery protocol LLDP-MED (optional)
Lines Up to 8 concurrent, independent extensions
Codec support Various ITU, including wideband
Default settings Link speed and duplex level = autodetected
IP address = 192.168.1.254
Subnet mask = 255.255.255.0
Default gateway = 0.0.0.0
DHCP = off
CONTROL/REMOTE
Serial host control port 1 bidirectional RS-232, 3.5 mm captive screw,
3 pole
Baud rate and protocol 38400 baud, 8 data bits, 1 stop bit, no parity
USB control port 1 front panel USB mini-B
ACP control port (1) 3.5 mm captive screw, 4 pole, supports up to
8 panels
Pin configuration 1 = +12V, 2 = +S, 3 = -S, 4 = G
Power supply 6 Watts max
Digital I/O (6) 3.5 mm captive screw, 6 pole
(shared with audio input)
Pin configuration 1 = In, 2 = G, 3 = Out 1
Voltage range Input = 0V to +12V
Output = 0V (low), 5V (high)
Software programmable
Ethernet host port 1 RJ-45
Data rate 10/100/1000 Base-T
Protocol ARP, ICMP, IP, TCP, DHCP, HTTPS, Telnet, SSH
Web server Up to 200 simultaneous sessions
Program control Extron DSP Configurator control/configuration
program for Windows
®
Extron Simple Instruction Set (SIS
¢
)
Microsoft
®
Internet Explorer
®
, Telnet
GENERAL
Power supply External
Input: 100-240 VAC, 50-60 Hz
Power input requirements 12 VDC or Power over Ethernet Plus
(PoE Plus IEEE 802.3at)
DMP 64 Plus C V AT — power consumption
PoE+ PSE
Device 21.7 watts
Power supply (PS 1220)
Device and power supply 20.4 watts
DMP 64 Plus C V AT — thermal dissipation
Power supply (PS 1220)
Device and power supply 53.5 BTU/Hr
Cooling Fan, front to back, variable speed, OFF when
ambient temperature is less than 45°C
Mounting
Rack mount Yes, with optional 1U rack shelf
Furniture mount Yes, with optional under-desk mounting kit
Enclosure dimensions 1.7" H x 8.7" W x 9.5" D (1U high, half rack wide)
(4.3 cm H x 22.1 cm W x 24.1 cm D)
Regulatory compliance CE, c-UL, UL, CE, C-Tick, FCC Class A, ICES, RoHS,
VCCI, WEEE
Warranty 3 years parts and labor
NOTE:
All nominal levels are at ±10%.
Model Version Description Part number
DMP 64 Plus C 6x4 Digital Matrix Processor w/ AEC 60-1823-01
DMP 64 Plus C AT 6x4 Digital Matrix Processor w/ AEC and Dante 60-1823-10
DMP 64 Plus C V 6x4 Digital Matrix Processor w/ AEC and VoIP 60-1824-01
DMP 64 Plus C V AT 6x4 Digital Matrix Processor w/ AEC, VoIP, & Dante 60-1824-10
For complete specifications, please go to www.extron.com
Specifications are subject to change without notice.
To Next Page
Loading...