Attero Tech unD6IO-BT User Manual

Attero Tech unD6IO-BT

123 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

APPENDIX F

PAGE 1 OF 123

HMC 8EH Burn Upgrades

UW Project Number: 206970

Ankrom Moisan Architects

March 16, 2020

AMA PROJECT NUMBER 192190 Section Prepared by Stantec

APPENDIX F

THIS SECTION IS SUBMITTED FOR REFERENCE ONLY

ALL CONTRACTOR REQUIRED SCOPE IS INDICATED ON THE DRAWINGS

1. Narrative

2. Bluebeam markup

3. Datasheets

4.OOPC (Equipment List and Probable Cost)

Table of Contents

Questions and Answers:

D
Deborah ProctorAug 5, 2025
What to do if Attero Tech Accessories have no sound?
- N
  Nancy MartinezAug 5, 2025
  If you're experiencing no sound or low sound with your Attero Tech Accessories, consider the following possible causes: The input signal might be absent or very low, in this case increase the input signal level. The Master Volume control could be turned down, so turn it up. If a CSR-V is connected, ensure it is turned up. If using 70V or 100V outputs, verify the Hi-Z switch is ON. Finally, check that the power switch is ON.
A
Angela EvansAug 14, 2025
Why is the sound distorted from Attero Tech unD6IO-BT Accessories?
- E
  Eric StewartAug 14, 2025
  Distorted sound from Attero Tech Accessories can occur if the input signal level is too high. Please turn down the input level controls. Alternatively, the Master Volume might be set too high, so reduce the Master Volume.

Attero Tech unD6IO-BT Specifications

General

Brand	Attero Tech
Model	unD6IO-BT
Category	Accessories
Language	English