ATX ucrypt q2q - IMPORTANT CONFIGURATION INFORMATION; Support for Two Configurations; Applied Configuration

IMPORTANT CONFIGURATION INFORMATION
MDU Solutions
®
– UCrypt
®
QAM to QAM – Quick Start Guide 3-1
IMPORTANT CONFIGURATION INFORMATION
3. Important Conguration Information
3.1 Support for Two Simultaneous Congurations
As work on conguration progresses, changes will need to be made to multiple pages in the Management Interface. As work is
completed on each page, the changes must be saved and there is a Save button conveniently located on every conguration
page where conguration changes can be made. If changes are made and you navigate away from the page without saving,
the changes may be discarded.
When you are satised that all conguration changes on the UCrypt device are complete and correct, click the Apply button
located by the save buttons on any page, they all do the same thing. There is no need to apply the conguration as you
complete work on each page. You may Save your work as you go and Apply the conguration when completed.
3.1.1 Saved Conguration
This can be thought of as a work in progress and any changes can be made in the conguration without affecting how the
UCrypt device is currently working and providing services.
This saved conguration can be discarded at any time without affecting the working UCrypt device conguration or can be
Applied to the UCrypt device, to make it the new working conguration. To discard your conguration changes browse to the
Conguration tab and click the Revert button. The Revert action is not service affecting.
3.1.2 Applied Conguration
This is the working conguration that the UCrypt device is currently using to provide the desired services to the output and
regardless of the changes made in the Management Interface as discussed above, changes do not take effect until the Apply
button is clicked and the conguration is applied.
During conguration, while changes are being made, the saved conguration and the applied conguration differ by the
changes that have been made and saved since last clicking Apply. After the Apply button is clicked, the saved conguration
and the applied conguration are identical.
NOTE: Clicking the Apply button will cause a service interruption while the UCrypt device re-
provisions itself with the new working conguration. It is best to make all changes necessary on all
conguration pages and apply the changes when completed.
CHAPTER 3: