When the Clip LED illuminates, the output limiter of the amplifier will intervene avoiding a
distorted āClippingā sound on the output. The Protection LED will illuminate when overheating
occurs or any other fault is detected. When the protection LED is illuminated, no signal will
be present on the outputs.
When the level for multiple outputs should be adjusted simultaneously, press and hold their
channel selection buttons for about 3 seconds. The desired channels will be simultaneously
selected and changes will apply to all selected channels.
Power switch:
A power switch allows to switch the amplifier on and off, while the blue indicator LED located
next to the button illuminates when the power is switched on.
To Next Page
