Output setup >> Phase reverse
Phase reverse will shift the phase of the output over 180° with the input, for applications
where a contrary phase is desirable.
Output setup >> Roll off
Roll off allows to enable and disable a low-cut filter to the selected output. When the
low-cut filter is enabled, frequencies below 50 Hz will be suppressed. This can be useful
for eliminating low-frequency hum and noise caused by external equipment and protects
speakers from damage caused by excessive low frequency transients.
Output setup >> Output type
Output type allows to switch the channel between 100V and 8 Ohm (low impedance)
operation mode. This setting is standard set to 100V mode and can be changed for each
channel individually, offering optimal flexibility for installations with 100V and low impedance
loudspeakers combined. Typical applications are venues with 100V high frequency widely
spread and low impedance bass cabinets added.
Output setup >> Clear presets
Loudspeaker and total system (set) configurations can be uploaded to the amplifier. Every
preset is made and optimized for one specific loudspeaker or system. This window will
indicate if any preset is currently loaded. Presets which are meant for others than the
connected loudspeakers may affect the performance and sound quality in negative way,
while not providing optimal protection.
Clearing of the currently loaded presets can be done by selecting this option and pressing
clear. Please note that other configurations for the corresponding channel (Eg. filters,
equalizing, … ) which are separately made from the preset will remain unchanged. When a
total system configuration (set solution *.SOL) is currently loaded and cleared, other channel
configurations which are part of this preset will be cleared too.
General setup
The general setup will lead you to a separate menu where some global configuration settings
for the amplifier can be made. Typical settings accommodated under general setup are
password settings, …
To return from the output setup menu back to the main menu, the ‘back’ option at the bottom
needs to be pressed.
To Next Page
