AUDAC PMQ240 - Chapter 5: Configuring the Amplifier; Menu Structure Overview

19
Chapter 5
Configuring the amplifier
The configuration of the amplifier can be done using the controls on the front panel of
the amplifier. A graphical user interface is indicated on the front panel LCD display which
guarantees an intuitive and user friendly experience. The menu structure is shown in below
diagram, giving an overview of the configuration possibilities. The following pages give a
detailed explanation for every configurable function.
Level
Input
Mute
Output setup
General setup
Lock
Back
-70 dB ~ 0 dB
Off
Mute Off / On
Low pass
Type: - Off - Buerworth - Bessel - Linkwitz - Riley
Roll-off: - 12 dB / Oct - 24 dB / Oct
Frequency: - 1 Hz ~ 22 kHz (Steps of 1 Hz)
High pass
Type: - Off - Buerworth - Bessel - Linkwitz - Riley
Roll-off: - 12 dB / Oct - 24 dB / Oct
Frequency: - 1 Hz ~ 22 kHz
(Steps of 1 Hz)
EQ Sengs
Back EQ Frequency:
- Band 1 – 7 Freq sengs 1 Hz ~ 22 kHz (Steps of 1 Hz)
EQ Q-factor: - Band 1 – 7 Q factor seng 0.1 ~ 15 (Steps of 0.1)
Back
Back
EQ Level - Band 1 – 7 EQ level seng +15 dB ~ -15 dB (Steps of 1 dB)
Input 1 Input 2 Input 1 + 2 Input 3 Input 4 Input 3 + 4
Input gain
Input 1 Input 2 Input 3 Input 4 Back
-16.5 ~ 30.75 dB
(Steps of 0.75 dB)
Admin password
Change admin password
Adjustable from ‘0000’ to ‘9999’
User password
Change user password
Adjustable from ‘0000’ to ‘9999’
LCD
Brightness: - 10% ~ 100%
Backlight off:
- Never ~ 120 min
Lock device
Delay
0 ~ 12 meter
(Steps of 0.1)
Up to 35 ms
Max level
0 dB ~ -70 dB
Standby
Never ~ 120 min
Limiter Phase reverse
Off / On
Rol-off
Off / 50 Hz
Output type
100 V / 8 Ω
Clear presets
Clear / Cancel
Back
USB
Save: - Save sengs to USB drive
Load: - Load sengs
from USB drive
Admin key: - Create USB key
with admin access
Back
User key: - Create USB key with user access
Info
Model name
Soware version
Temperature Temperature
level for each
channel
Factory reset
Recall sengs to
factory default
Back
Off / On