Current fuel mileage
The instantaneous fuel consumption in miles
per gallon (l/100 km) is shown in this display.
You can use this display to adjust your driving
technique to achieve a desired mileage .
Fuel cons umption is recalculated at intervals
of 33 yards (30 meters). This display switches
to gallons/hour (liters/hour) when the vehicle
is not moving.
Average speed
The ave rage speed in mph (km/h) s ince t he
last time the disp lay was reset appears in the
display .
Elapsed time
The length of time that you have been driving
since you last reset the memory appears in
this display .
Distance
The distance that has been covered s ince the
last time the memory was cleared appears in
the disp lay.
@ Tips
- Fuel consumptions (average and cur-
rent), range and speed are displayed in
metric units on Canadian models .
- All stored va lues will be lost if the veh i-
cle battery is disconnected.
Memories
Applies to vehicles: with trip computer
The trip computer is equipped with two fully
automatic memories as well as an efficiency
program*.
Fig. 17 Trip computer display: memory level 1
Driver information display 23
You can switch between the trip computer 1
and 2 and the efficiency program* by pressing
the
I RESET I button @ ¢ page 23, fig. 18 .
You can tell wh ich memory leve l is currently
active by the number or the sign in the display
~ fig. 17. The data from the single-trip mem-
ory (memory level 1) is being displayed if a
0
appears in the display. If a fJ is shown, then
the data from the total-trip memory is being
displayed (memory level 2) . The fue l pump
nozzle
W., indicates the efficiency program*
~ page 24 .
Single-trip memory (Trip computer 1)
The single-trip memory stores the trip infor-
mation from the time the ign ition is turned on
until it is turned off. If the tr ip is cont inued
within 2 hours from the time the ignition was
turned
off, the new data will be included in
the calculation of the current trip informa-
tion. If the trip is interrupted for more than 2
hours
the memory is reset automatically.
Total-trip memory (Trip computer 2)
Unlike the single-trip memory, the total-trip
memory is not reset automatically . This per-
mits you to evalua t e your driving data for the
entire period between manua l resets.
Efficiency program*
The efficiency program can help you to use
less fuel ¢
page 24 .
Operation
Applies to vehicles: with trip computer
The trip computer is controlled by two
switches on the windshield wiper lever.
Fig. 18 Windsh ield wiper lever: contro ls for the t rip
comp uter
To Next Page
Loading...
