_& WARNING
- Adjust the driver's seat only when the ve-
hicle is stationary . You risk an accident
otherwise .
- The power adjustment for the front seats
also works with the ignition switched off
or with the ignition key removed. For this
reason, children should never be left un-
attended in the vehicle - they could be in-
jured!
- Exercise caution when adjusting the seat
height. Unsupervised or careless seat ad-
justment can pinch fingers or hands
causing injuries.
- While the vehicle is moving, the seat
backs of the front seats must not be in-
clined too far to the rear because the ef-
fectiveness of the safety belts and the
airbag system is severely compromised -
there is a risk of injury.
Seat memory
Memory for driver's seat
Applies to vehicles: with seat memory
The seat adjustment settings for two drivers
can be stored using the memory buttons in
the driver's door.
Fig. 70 Driver' s door : Seat memory
In addition to the setting for the driver's seat,
the exterior rear view mirror setting can be
stored and recalled through seat memory if
the vehicle is properly equipped.
Seats and storage 65
Storing and recalling settings
With the he lp of the memory buttons 1 and 2
¢ fig. 70 the settings for two different drivers
can be stored and recalled
¢ page 65.
The current sett ings are also automatical ly as-
signed to t he remote control key being used
when the vehicle is locked. When the vehicle
is unlocked, the settings assigned to the re-
mote control key being used are automatically
recalled.
Turning seat memory on and off
If the IOFFI switch is depressed, the seat
memory is inoperative. The word
OFF in the
IOFFI switch illuminates.
All the stored settings are reta ined . We rec-
ommend using the
IOFFI switch and deactivat-
ing the seat memory if the vehicle is only go-
ing to be used
temporarily by a driver whose
settings are not going to be stored.
Storing and recalling settings
Applies to vehicles: with seat memory
Before you can store or recall your settings,
the
IOFFI switch on the seat memory must be
engaged (not raised) .
Storing settings
.,. Adjust the driver's seat .
.,. Adjust the two exterior mirrors .
.,. Press the
ISETI button and hold it down . In
addition, press one of the memory buttons
for at least one second .
.,. Release the buttons . The settings are now
stored under the corresponding memory
button.
Recalling settings
.,. If the driver's door is open, tap the corre-
sponding memory button briefly .
.,. If the driver's door is closed, press the ap-
propriate memory button until t he sto red
position is reached.
Successful storage is confirmed audibly and
by the light in the
ISETI button illuminating
¢ page 65, fig. 70. Ill>-
To Next Page
Loading...
