2 4 Dr iv er in f ormation d is play
• To disp lay th e trip computer memory levels,
press the
I RESET I button ® ~ fig . 18 re-
peatedly unt il the desired memory leve l is
shown in the d isplay.
• To d isplay trip information within a memory
level, press the top or bottom part of the
function selection switch @ .
The trip computer will not operate unless the
ignit ion is on . Whe n you turn on the ignition,
the function that was in use when you last
turned the ignit io n off will be d isp layed .
In addition to information on the trip comput-
er (trip computer 1 and 2 and the efficiency
program*) , the dig ital speedometer* and in-
formation regard ing the navigation system*
can also be d isp layed. To sw itch the display
between the different informa t ion, tap the
I RESE T I button ® briefly.
Setting values to zero
To delete one current value from the trip com-
puter, select the desired function and press
the
I RESE T I button @ for at least one second.
The fo llow ing val ues can be se t to zero
indi-
vidually :
- Average fuel mileage
- Average speed
- Elapsed time
- Distance
All current ly displayed values are deleted in
the efficiency program *.
In addition,
all the values in t he single-t rip or
the t ota l-t rip memory can be deleted simu lta-
neously ~
page 24.
@ Tips
All stored values will be lost if t he vehicle
battery is disconnec t ed .
Basic Settings for the trip computer
Applies to vehicles: with trip computer
The radio or MM!* operating unit is used for
setting the trip computer 's basic settings .
• Select: Function button ICAR! > Instrument
cluster > On-board computer 1 or On-board
computer
2 .
The values in the sing le-tr ip or the total-trip
memory can all be reset to zero at the same
t ime under
Reset in the menu .
In add ition, you can determine what info rma-
t ion from the trip computer should be shown
in the instrument cluster display. If one of the
pieces of driver information is turned
Off, that
driver information will not be shown in the
display . The info rmation will continue to be
ca lculated by the tr ip comp ute r and can be
tu rned back
On at any ti me.
@ Tips
The dr iving information in the efficiency
program* is also reset to ze ro with the sin-
gle-tr ip memory.
Efficiency program
Description
Appl ies to vehicles : with trip computer with efficiency
program
Fig. 1 9 Display: eff iciency prog ram
• Press the I RES ET I button ® ~ page 23,
fig. 18
repeatedly unt il t he effi ciency pro-
gram appea rs in the display .
The efficiency program can he lp you to use
less fue l. It evaluates d riving info rmation in
IJJ,,,
To Next Page
Loading...
