28 Dr ive r information d is play
@ Tips
Even though your vehicle is equipped with
a speed warning system, you should still
watch the speedometer to make sure you
are not driving faster than the speed limit.
Speed warning 1: setting a speed limit
Warning threshold 1 is set by the !SETi but -
t on.
Fig. 24 SET butto n in the i nstr ument cluster
Storing the maximum speed
" Drive at the desired maximum speed.
" Press the
!SETi button in the instrument
panel display ~ fig. 24 for 1 second.
Resetting the maximum speed
" Drive the vehicle at a speed of at least
3 mph (5 km/h)
" Press the
!SETI button for more than 2 sec-
onds.
The . (USA models)/ . (Canada models)
speed warning symbol will appear briefly in
the display when you release the
ISETI button
to indicate that the maximum speed has been
stored successfully.
The maximum speed remains stored until it is
changed by pressing the ISETI button again
briefly or until it is deleted by a lengthy push
on the button .
Speed warning 2: setting a speed limit
Applies to vehicles: with trip computer
The radio or MMI* control unit is used to set,
change or delete warning threshold
2.
" Select: Function button iCAR! > Instrument
cluster> Speed warning.
Warning threshold 2 can be set in the speed
range starting from 20 mph to 150 mph (30
km/h to 240 km/h). Settings can each be ad-
justed in intervals of 6 mph (10 km/h) .
Auto Check Control
' Introduction
The Auto-Check control monitors the function
of certain vehicle features and components. It
simply makes sure these features and compo-
nents are working properly . The Auto-Check
control works as long as the ignition is on, as
well as whenever the vehicle is driven .
If a component is malfunctioning or if the
need for an urgent repair has been detected,
this will appear in the instrument cluster dis-
play. You w ill also hear an audible warning
tone. The displays are color coded in either
red or yellow depending on their level of prior-
ity.
A red symbol means Danger, a yellow symbol
indicates
Warning. In certain situat ions, in-
format ion message for the driver appear in
addition to the red and yellow symbols .
Function test: automatic transmission*
The Auto-Check Control will automatically
perform a test each time you switch on the ig -
nition . With the selector lever in
P or N, the
following message appears in the display:
When stationary apply foot brake while se-
lecting gear.
When you a select a different gear (for exam-
ple:
R, D, etc.), the message will disappear
and the Auto-Check funct ion is displayed . .,..
To Next Page
Loading...
