If there is a ma lfunction, then the malfunc-
tion message will appear about 15 seconds af-
ter you start the veh icle. At the same t ime you
will hear a warning tone.
Driver information messages
Driver information messages ore shown in the
instrument cluster display in addition to sym-
bols.
Fig. 25 Instrument cluste r : SET butto n
For example, if the transmission selector lever
is not in the
P posit ion when the engine is
turned off, the following message appears:
Shift to P, otherwise vehicle can roll away.
Doors do not lock if lever is not in P.
The ignition key can only be removed with the
selector in this position . This and other mes-
sages are brought up if a funct ion cannot be
carried out.
Driver messages and red symbols
If a red symbol appears in the display, a driver
message is also displayed automat ically .
For example, the . symbol for a problem
with engine oil pressure appears in the dis-
play. The message:
Switch off engine ! Oil pressure too low
The driver message in the display goes out af-
ter about 5 seconds. The driver message can
be disp layed again by briefly pressing the
ISETI button c::>fig . 25.
Driver information display 29
Driver messages and yellow symbols
If a yellow symbol appears in the display, a
driver message is also displayed automatical-
ly.
For example, the
L ..... j symbol appears in the
display, indicating low windshie ld washer flu-
id level. The following message also appears:
Please refill washer fluid
The driver message disappears after a few
seconds . The driver message can be displayed
again by br iefly press ing the
ISETI button .
Red symbols
A red symbol means DANCER.
Fig. 26 Display: Danger symbol
... Pull off the road.
... Stop the vehicle.
... Turn off the engine .
... Check the malfunctioning system. Contact
your authorized Audi dealer or a qualified
workshop for assistance.
Red symbo ls indicate a priority 1 mal function
- Danger!
With a priority 1 ma lf uncti on, a red symbol
appears in t he uppe r cente r area of the dis -
play
c::> fig . 26. A driver message appears as
well to explai n the ma lfunction in more de-
tai l. When this symbol appears ,
three warning
tones sound in succession . The symbol contin-
ues to flash until the fault has been corrected.
If
several priority 1 malfunctions are present,
the symbols appear in succession and remain
for about 2 seconds.
Ill>
To Next Page
Loading...
