Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6.1.2 Replacement parts
Outer side member
Solid rivets
Body - adhesive
6.1.3 Welding in
Preparing new parts
– Match up new parts to body.
– Transfer separating cuts to new parts.
– Prepare flanges on body and new parts for welding.
– Prepare joints for adhesive application.
Note:
Refer to General notes on bonding.
– Apply adhesive.
– Fit side member and fix in position.
Caution:
Fit side member with no load on body.
Note:
Check panel gaps with doors fitted.
– Punch flanges.
– Fit solid rivets in flanges.
– Fit solid rivets in wheel housing liner.
– A-pillar, SG continuous seam.
– B-pillar, SG continuous seam.
– Side panel, SG continuous seam.
– Separating cut, SG continuous seam.
Audi A8 1994 ➤
Body repairs - Edition 10.1998
58 Rep. Gr.51 - Body - centre
To Next Page
Loading...
