Audi A8 - Procedure

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Pneumatic sabre saw -V.A.G 1523A-
2.2 Procedure
Cutting locations
– Roughly cut out rear cross member using pneumatic sabre
saw -V.A.G 1523A- .
– Detach part.
– Remove remaining material using compact angle grinder -
VAS 5167- .
Audi A8 2003 ➤
Body Repairs - Edition 05.2011
2. Rear cross member - Renewal 99