Audi A8 - Procedure

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ When using the rechargeable riveter -VAS 5279A- , the at‐
tachment set -VAS 5279/2 - is also required.
♦ Alternatively, you can use the new rechargeable riveter -VAS
5279B- . This is a complete set.
♦ Pneumatic sabre saw -V.A.G 1523A-
1.2 Procedure
Cutting locations
– Roughly cut out rear cross panel using pneumatic sabre saw
-V.A.G 1523A- .
– Separate original joint with rechargeable riveter -VAS 5279A- .
– Remove remaining material using compact angle grinder -
VAS 5167- .
Audi A8 2003 ➤
Body Repairs - Edition 05.2011
1. Rear cross panel - Renewal 95