EasyManua.ls Logo

Audi Q3 2017 - Windshield Wipers

Audi Q3 2017
236 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Light s and Vision
Windshield wipers
Switching the windshield wipers on
Fig. 4 1 Wind shield wiper lever
Fig. 42 Actua te the rear window wipe r
Move the windshield wiper lever to the corre-
spond ing pos ition:
@ - wipers off
(D - interval mode. To increase/decrease the wip-
er intervals, move the switch @ to the left/right.
In vehicles with a ra in sensor *, the wipers turn on
in the rain once the vehicle speed exceeds ap-
proximate ly 2 mph (4 km/h) . The higher the rain
sensor sensitivity is set (switch @ to the right),
the earlier the windshield wipers react to mois -
ture on the windsh ield .
@ - slow wiping
@ - fast wiping
©-sing le wipe If you hold t he leve r in th is posi-
tion longer, t he wipers sw itch from slow wiping
to fast wiping.
® - clean the windsh ield The wipe rs wipe one
time afte r several seconds of dr iving to remove
water drop lets . You can switc h this func t ion off
by moving the lever to position ® within 10 sec-
onds of the afterwipe . The afterwipe function is
40
reactivated the next time you switch the ignit ion
on .
® -wipe t he rea r window. The rear wiper moves
about every 6 seco nds.
0 -clean the rea r window . The number of wipes
depends on how long the lever is held in pos it ion
(i).
& WARNING
- The rain sensor is on ly intended to ass ist t he
driver . The driver may still be responsible
for manually switch ing the wipers on based
on visibility conditions .
- The windsh ield may not be treated with wa-
ter-repelling windshield coating agents . Un-
favorable conditions, such as wetness, dark-
ness, and when the sun is low, can cause in-
creased glare, wh ich increases the risk of an
accident . Wiper blade chatter is also possi-
b le .
- Properly functioning windshield wipe r
blades are required for a clear view and safe
driving
~
page 41, Replacing front wind-
shield wiper blades.
(D Note
- If there is frost, make sure the windshield
wiper blades are not frozen to the wind-
shield . Switch ing on the windshield wipers
when the blades are frozen to t he wind-
shield can d am age the wiper blades.
- Prior to using a car was h, the windshie ld
wiper syst em mus t be sw itche d off (lever in
posit ion @ ) . This preven t s t he wipers from
switching on unint entionally and causi ng
damage to the windsh ield wiper system .
(D Tips
- The windshie ld wipers switch off when t he
ignition is switc hed off . You can activate t he
windshield wipe rs after the ignition is
switched back on by moving the windshield
wiper lever to any position .
- Wor n or dirty windshield wiper blades resu lt
in streaking. This can affect the rain senso r*
function. Check your windshield wiper
blades reg ula rly. .,.

Table of Contents

Related product manuals