EasyManua.ls Logo

Audi Q3 2017 - On Board Diagnostic System (OBD)

Audi Q3 2017
236 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
a:,
a:,
......
N
r--.
N
....
0
0
::,
a:,
; Adaptive dampers
App lies to: vehicles with Audi drive select and suspension con-
tro l
B Suspen sion: system fault !
There is an adaptive damper malfunction .
Drive to an aut horized Audi dea ler or authori zed
Audi Service Facility immediately to have the
malfunct ion corrected.
¢¢ Turn signals
If the II or i!I indicator light blinks, the turn
signals are activated. If both indicator lights are
blinking, the emergency flashers are act ivated.
If an indicato r light blinks twice as fast as usua l,
a t urn signa l bulb has failed . Carefully drive to an
author ized Audi dealer or author ized Audi Service
Facility immediately to have the malfunction cor-
rected.
¢1.~ Trailer turn signal assembly
The indicat or light II blinks when t he turn sig-
nal is used , if a tr ailer has been properly connect -
ed to the vehicle.
If one of the turn signal bulbs on the trailer is
burned out or defect ive, the indicator light will
not blink when you use the t urn signals.
(D Tips
For vehicles with a t railer hitch that was in-
stalle d later accord ing to factory spec ifica-
tions, t he tr ailer tur n signal assembly is actu -
at ed.
/fJl~/c:5 Door, hood or luggage
compartment lid is open
IJ-If the indicator light tu rns on, then one of
the doors is not closed.
&-\-If the indicator light t urns on, then the hood
is not closed .
§-j- If the indicator light tu rns on, t hen t he lug-
gage compartment lid is not closed .
Instruments and indicator lights
On Board Diagnostic
System (OBD)
Malfunction indicator lamp (MIL)
The malfunction indicator lamp (MIL) Ill in t he
inst rument cluste r is pa rt of the On Board Diag-
nostic System (OBD II).
The warning/i ndicator light tu rns on when t he ig-
nition is switche d on and tu rns off once the en-
gine is starte d and is running in idle at a stab le
speed. This indicates t hat the MIL is functioning
correctly.
If the light does not turn off after starting the
engine or t urns on while driving, this may indi-
cate there is a malfunction in the eng ine. If the
indicator tu rns on, the catalytic converter may be
damaged .
Drive
with reduced engine performance (avoid
high speeds for extended periods of t ime and/o r
fast acceleration) and have the malfu nction cor-
rected . See an author ized Audi dealer or author -
ized Audi Service Facility.
The indicator may turn on if the electronic speed
limiter is faulty . For addit ional information, see
¢ page 18, Electronic speed limiter .
The MIL may also turn on if the fuel filler cap is
not closed correctly ¢ page 157.
On-Board Diagnostics
Fig. 5 Locat ion of Data Link Connecto r (OLC)
On-Board Diagnostics monitors the components
of your emission control system . Each monitore d
I>-
17

Table of Contents

Related product manuals