EasyManua.ls Logo

Audi Q3 2017 - Page 59

Audi Q3 2017
236 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IAUTO I Switching automatic mode on and off
Automatic mode ma inta ins a constant tempera-
ture ins ide the vehicle. Air temperature, airflow
and air distribution are controlled automatically.
- I - Adjusting the temperature
The vehicle inte rior temperature can be adjusted
for the driver and the front passenger us ing the
left/rig ht knob. Temperatures can be set be-
tween a range of 60 °F (+ 16 °() and 84 °F
(+28 °C). Outside of this range,
LO or HI will ap-
pear in the climate control system display. At
both of these settings, the climate contro l sys-
tem runs continuously at maximum cooling or
heating power. There is no temperature regula -
tion .
~
Adjust ing the blower
You can adjust the volume of air generated by the
blower to your preference. Use the left
l!:I button
to decrease the a ir speed, and use the right
lj]
button to increase the air speed . The blower
should always run at a low sett ing to prevent the
windows from fogging and to ensure a continu-
ous exchange of air ins ide the veh icle. To have
the airflow regulated automatically, press the
IAUTO ! button.
~ /l;o!/h
0
! Adjusting air distribution
You can manually select the vents where the air
will flow. The buttons can be pressed individually
or in combination with each other. To have the air
d istribution regulated automatical ly, press the
IAUTO ! button .
~
Adjusting the seat heating*
Pressing the button switches the seat heating on
at the highest setting (level 3). The LEDs ind icate
the temperature level. To reduce the tempera-
ture, press the butto n again . To switch the seat
heating off, press the button repeatedly until the
LED turns off.
Afte r approximately 10 minutes, the seat heating
a utomatically switches from level 3 to level 2.
00
~
I@ MAXI Switching the defroster on and off
"'
,....
~
The windshield and s ide windows are defrosted
0
g or cleared of condensation as quickly as possible.
00
Warm and cold
The maximum amount of air flows mainly from
the vents below the windshield . Recirculation
mode switches off. The temperature should be
set at +72°F (22°() or higher.
The
!AUTOI button switches the defroster off.
llilil REAR ! Switching the rear window defogger
on and off
The rear window defogge r on ly operates when
the engine is running and will be automatically
switched off after approximate ly 10 minutes .
Synchronization
If you press the
IAUTO I button longer, you can
transfe r the d river temperature setting to the
front passenger. Synchronization is switched off
as soon as the temperature for the front pas-
senger's side is changed.
Air vents
You can open or close the center and rear vents in
the cockpit and the vents in the rear center con-
sole using the ridged thumbwheels . The levers
adjust the direction of the airflow from the vents.
Switching the temperature measurement
units
The temperature display can be switched be-
tween°( and °F. Press and hold the
l,e,,:,.I button
r=;, fig. 67 and turn the knob on the driver's side to
- for three seconds.
A WARNING
-
- You shou ld not use the recirculation mode
for an extended period of time since no
fresh air is drawn in. With the air-condition-
ing switched off, the windows can fog up,
which incre ases the risk of an accident.
- Indiv iduals with reduced sensit ivity to pa in
or temperature could develop burns when
using the seat heating* function. To reduce
the risk of injury, these individua ls should
not use seat heating*.
0 Note
To avoid damaging the seat heating* ele-
ments, do not kneel on the seats or place
heavy pressure on one area of the seat.
57

Table of Contents

Related product manuals