Driver voice activation
Maintain pushed to talk
4 variable* speeds (40/50/60/80)
Short push to activate/deactivate
Double short push to activate
Single short push to deactivate
Short push to activate/deactivate
Short push to change display page / rolling change
Safety brake
signal button
Allows moving the gear lever without pressing the brake
pedal. IMPORTANT: the use of this button is under user
responsibility, a bad use of it may cause fatal damages on
the gearbox.
Short push to roll diff map 1/2/3
Diff map number is shown on the AIM MXG display
Map 1: Use when grip is high (new tyres or good grip)
Map 2: Use when medium grip (used tyres)
Map 3: Use when grip is low or rain
Active if gearbox is in Neutral or the clutch is pressed
Active if rpm < 500
4 variable* speeds (40/50/60/80)
Active if rpm > 500 and speed > 5 km/h
Short push to activate/deactivate
Activates water pump
Note: pump not supplied with the car
Short push to activate/deactivate
Short push to roll low speed/high speed/deactivate
Long push to activate water splash + wiper activation
Short push to flash
Long push to activate/deactivate
A led informs when tip up or down
Usual status: led off
If there is a CAN Bus problem: led on