17
1. Use only fresh alkaline batteries. Do not use “general
purpose” (carbon-zinc) batteries.
2. Position the receiver so that it has the fewest possible
obstructions between it and the normal location of the
transmitter. Line-of-sight is best.
3. The transmitter and the receiver should be as close
together as conveniently possible, but no closer than
three feet (1 m).
4. Avoid placing the receiver in a low or shielded
locationwhere the transmitter and receiver antennas are
not visible to each other. If necessary, use remotely-
located receiver antennas.
5. Avoid placing the receiver near computers or other RF
generating equipment.
6. The receiver and transmitter must be set to the same
frequency.
7. A receiver cannot receive signals from two transmitters at
the same time.
8. Do not obstruct the handheld transmitter’s antenna
(located at the base) or attached body-pack transmitter’s
antenna with your hands.
9. You need to change frequencies 1) when a strong
interference signal is received, 2) when audio quality is
poor due to weak RF, or 3) during multiple-system
operation in order to select an interference-free
frequency.
10. Turn the transmitter off when not in use. Remove the
batteries if the transmitter is not to be used for a period
of time.
Ten Tips to Obtain the Best Results
For future reference, please record your system information here:
Receiver ATW-R3100___ S/N
Serial Number appears on the label on the back of the receiver.
Transmitter ATW-T310___ S/N
Serial Number appears on the label on the back of the transmitter.
ATW-T341___ S/N
Serial Number appears in a recess in the battery compartment of the transmitter.
ATW-T371___ S/N
Serial Number appears in a recess in the battery compartment of the transmitter.
E
N
3000 Series OM (Nov.08).qxd:12MAY3000OM.qxd 26/11/08 16:15 Page 17
To Next Page
Loading...
Need help?
General
