EasyManua.ls Logo

Audio Technica 3000 Digital Series - User Manual

Audio Technica 3000 Digital Series
37 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
User Manual
Digital Wireless Systems
ATW-DR3120
Dual Receiver
ATW-DR3120DAN
Dual Receiver with Dante Output
ATW-DT3101
Body-Pack Transmitter
ATW-DT3102
Handheld Transmitter (without capsule)
3000 Digital Series

Table of Contents

Questions and Answers

  • A
    amberellisAug 12, 2025
    What to do if there is unwanted noise or sound drop-out occurs on Audio Technica 3000 Digital?
    • J
      jennifer97Aug 12, 2025
      If you're experiencing unwanted noise or sound drop-outs with your Audio Technica Receiver, try these steps: * Ensure there are no nearby noise sources like fluorescent lamps or electrical devices. * Make sure multiple units aren't used simultaneously across different groups. * Verify the receiver's output jack is correctly connected. * Confirm the receiver isn't powered from an outlet shared with a noisy device. * Check that other wireless systems nearby aren't using the same frequency band. * Review the PIN code, AES-256, and HD mode settings.
  • S
    Shelley WalshAug 21, 2025
    Why is there no voice output from my Audio Technica 3000 Digital?
    • J
      John GilmoreAug 21, 2025
      If you're not getting any voice output or the voice output level is low on your Audio Technica Receiver, here are a few things to check: 1. Make sure the transmitter/receiver channels are correctly set. 2. Verify that the power buttons on both the transmitter and receiver are turned on. 3. Ensure the antennas are properly connected. 4. Confirm that all connected devices, like a mixer, are correctly connected to the receiver. 5. Check that the audio output isn't set to the minimum level. 6. Verify that the audio output levels of devices connected to the receiver, such as a mixer, are not minimized. 7. Review the PIN code, AES-256, and HD mode settings.
  • C
    chelsea86Aug 31, 2025
    How to fix distorted sound on Audio Technica Receiver?
    • M
      Marcia NicholsAug 31, 2025
      If the sound from your Audio Technica Receiver is distorted, verify that the audio output level isn’t too high. Also, confirm that the volume of each connected device isn’t too high.

Audio Technica 3000 Digital Series Specifications

General IconGeneral
Modulation TypeDigital
Tuning Steps25 kHz
Audio Output ConnectorXLR, 1/4" (6.3 mm) phone jack
Power Supply12 V DC, 1 A
Dimensions210 mm x 44 mm x 168 mm (8.3" x 1.7" x 6.6")

Related product manuals