4
Notes on use
• Be sure to read the user manual for any device that you connect to the product.
• Disconnect the power cable from the outlet when this product is not in use.
• Turn off the power of this product before connecting or disconnecting cables.
• If you use the product near a TV or radio antenna, you may hear unwanted noise in the television or radio. If this occurs, move the product away
from the device.
• Two waves of the same frequency can’t be used simultaneously.
• Be careful of interference noise caused by the surrounding radio wave environment and use of multiple systems.
• Wireless systems may be affected by the spark noise of vehicles, the dimmers of lighting apparatus, computers, office automation devices, and
electronic musical instruments. Place and use the product where it is less likely to be affected by the above items.
• Be sure to use this product in combination with devices specified by Audio-Technica.
• Be sure to use a general-purpose LAN cable (CAT5e or higher, a cable with shielding is recommended) that complies with the Ethernet standard.
• Disconnect the LAN cable when not using the network.
• Be sure the connected cable is plugged all the way into the product.
• When you connect the product to a mixer, turn off the phantom power supply.
• If you use the product close to an electronic or communications device (such as a mobile phone), the product may produce unwanted noise.
If this occurs, move the product away from the device.
• When setting up the product, make sure there are no obstacles between the transmitter and the receiver that might block the signal.
• To prevent the batteries from wearing out, turn the transmitter off when not in use.
• Over time, discoloration may occur due to ultraviolet light (especially direct sunlight) and wear.
• Do not peel off the technical standards compliance certification sticker affixed to this product. Doing so will prevent you from using this product
legally.
• It is legally prohibited to dismantle and modify this product. In addition, this product is so precisely manufactured that dismantling it could cause
electric shock, failure, or fire. Never dismantle this product.
Using multiple wireless systems
• If you use more than one device at the same time, use them in the same group.
• When using multiple units simultaneously, maintain 1 meter or more between transmitters and 3 meters or more between transmitters and
receivers.
• When using multiple units, power on transmitters one by one, making sure there is no unwanted noise.
• When audio feedback (a beeping or squealing sound) occurs during use, turn down the output volume of the connected mixer/amplifier.
Maintenance
• If the product becomes dirty or covered with dust, be sure to disconnect the power cable before wiping the product off with a dry and soft cloth.
• Do not use benzine, paint thinners, electrical contact cleaner, etc. They may deform or otherwise damage the product or cause operational failure.
To Next Page
Loading...
Need help?
General
